PIC18F14K50-I/SS【PDF 32/285 页】IC PIC MCU FLASH 8KX16 20-SSOP

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3876

28页 29页 30页 31页 [32页]33页 34页 35页 36页

2010 Microchip Technology Inc.

Preliminary

DS41350E-page 127

PIC18F/LF1XK50

14.4.2.1

Direction Change in Full-Bridge

Mode

In the Full-Bridge mode, the P1M1 bit in the CCP1CON

direction. When the application firmware changes this

direction control bit, the module will change to the new

direction on the next PWM cycle.

A direction change is initiated in software by changing

the P1M1 bit of the CCP1CON register. The following

sequence occurs prior to the end of the current PWM

period:

The modulated outputs (P1B and P1D) are placed

in their inactive state.

The associated unmodulated outputs (P1A and

P1C) are switched to drive in the opposite

direction.

PWM modulation resumes at the beginning of the

next period.

See Figure 14-10 for an illustration of this sequence.

The Full-Bridge mode does not provide dead-band

delay. As one output is modulated at a time, dead-band

delay is generally not required. There is a situation

where dead-band delay is required. This situation

occurs when both of the following conditions are true:

The direction of the PWM output changes when

the duty cycle of the output is at or near 100%.

The turn off time of the power switch, including

the power device and driver circuit, is greater

than the turn on time.

Figure 14-11 shows an example of the PWM direction

changing from forward to reverse, at a near 100% duty

cycle. In this example, at time t1, the output P1A and

P1D become inactive, while output P1C becomes

active. Since the turn off time of the power devices is

longer than the turn on time, a shoot-through current

will flow through power devices QC and QD (see

Figure 14-8) for

the duration of

‘t’. The

same

phenomenon will occur to power devices QA and QB

for PWM direction change from reverse to forward.

If changing PWM direction at high duty cycle is required

for an application, two possible solutions for eliminating

the shoot-through current are:

Reduce PWM duty cycle for one PWM period

before changing directions.

Use switch drivers that can drive the switches off

faster than they can drive them on.

Other options to prevent shoot-through current may

exist.

FIGURE 14-10:

EXAMPLE OF PWM DIRECTION CHANGE

Pulse Width

Period(1)

Signal

Note 1:

The direction bit P1M1 of the CCP1CON register is written any time during the PWM cycle.

Period

P1A (Active-High)

P1B (Active-High)

P1C (Active-High)

P1D (Active-High)

Pulse Width

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式